SHARP VH3 MANUAL MILL

This mill is in really clean condition but has some feed problems. It features a 12 x 51 in. table with 14.8 x 37.4 in. travel. The vertical head is powered by a 5 hp, NST#40 geared head spindle while the horizontal head has a 7.5 hp, NST #50 geared head spindle. The mill has hardened and ground box ways and a built-in gear box that delivers feeds and rapids for the table, saddle, and knee. There is a joystick control for tapping (vertical) and a lever control for boring operation to move the quill up and down (vertical). The mill also has an electro-magnetic brake (vertical) and a backlash eliminator for climb milling.

12 x 51 in. table, 14.8 x 37.4 in. travel
5 hp, NST#40 geared head spindle for vertical head.
7.5 hp, NST #50 geared head spindle for horizontal head.
Hardened and ground box ways.
Built-in gear box that deliver feeds and rapids for the table, saddle and knee.
Joystick control for tapping. (vertical )
Lever control for boring operation to move quill up and down. (vertical )
Electro-magnetic brake. (vertical)
Backlash Eliminator for climb milling.
Located at our warehouse in Preston, Idaho
To the best of our knowledge all details listed below are deemed correct. It is the buyers responsibility to confirm ALL details prior to purchase.